Asus M3NEM • User guide • Download PDF for free and without registration!. Motherboard • Read online or download PDF • Asus M3NEM User Manual. M3nem, Quick start guide • Read online or download PDF • Asus M3NEM User Manual.
|Published (Last):||7 September 2010|
|PDF File Size:||14.93 Mb|
|ePub File Size:||17.60 Mb|
|Price:||Free* [*Free Regsitration Required]|
Ide Connector IDE cable.
Install the software drivers for the expansion card. Allows you to specify when the last write is registered by the DRAM. Page of Go. The edge with external ports goes to the rear part of the chassis as indicated in m3n87-em image below. Before installing the expansion card, read the documentation that came with it and make the necessary hardware settings for the card.
See page for the Utilities screen menu.
Operating instructions ASUS M3NEM |
Visit the ASUS website www. Updating Express Gate Express Gate software will be released regularly, adding refinements or new applications. Page Using the driver disks you created: This is a reminder that you should shut down the system and unplug the power cable before removing or plugging in any motherboard component.
Remove the onboard battery.
Asus M3N78-EM User Manual
Memory Configuration Enables or disables the memory remapping around memory hole. The utility copies the current BIOS file to the floppy disk.
Remove the jumper caps only when you intend to use the chassis intrusion detection feature. You can launch the EZ Flash 2 by two methods.
2 bios setup program – Asus M3N78-EM User Manual
The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. Failure to do so may cause you physical injury and damage motherboard components. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Don’t have an account? Detailed descriptions of the BIOS parameters are also provided. Assign an IRQ to the card. Detailed instructions for use are in the User’s Guide. M3n78-ek, you cannot snap the retention bracket in place. Page The most asud scenario is for your computer to automatically obtain network settings i.
Operation is subject to the mxnual two conditions: The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. Information to prevent damage to the components when trying to complete a task.
You’re reading an excerpt. Information to prevent injury to yourself when trying to complete a task. Remove mnual bracket opposite the slot that you intend to use. However, there is no guarantee that interference will not occur in a particular installation.
Asus M3NEM User Manual | 38 pages
This prevents incorrect insertion when you connect the IDE cable. Ensure that you use only qualified heatsink and fan assembly. Connect the serial port module cable to the connector, then install the module to a slot opening at the back of the system chassis. Supports four modules inserted into both the yellow slots and the black slots as two pairs of Dual-channel memory configuration. When no floppy disk is found, the utility automatically checks the optical drive for the original or updated BIOS file.
Align the other end of the retention bracket near the retention bracket m3j78-em to the retention module base. Got it, continue to print. Installing The Heatsink And Fan 1. If a USB device is detected, the icon contains a green arrow. Click File from the menu, then select Format.
The illustration below shows the location of the onboard LED. Do not forget to connect the fan cables to the fan connectors. Side Speaker Out port gray. This chapter describes the contents of the support CD that comes with the motherboard package. Dual channel DDR2 DDR2 memory provides great m3n78-ej for 3D graphics and other memory demanding applications on next generation memory technology.
Do not overtighten the screws! In other cases, the MHz memory modules can only run at MHz.
Follow these steps to install the CPU heatsink and fan. Save the BIOS file to a bootable floppy disk.